Salamander SYNERGY 345 Quad Assembly Download Page 3

Page: 3 / 4

Attach Hinges to Door Frames

Insert the hinges into the corresponding holes on

the doors. Turn the screws 1/4 turn to the right to

lock hinges in place.

NOTE: Do not over tighten

or the hinge will break.

Door Pull

Screw the Door Pull into place.

Adjust Clearance

Doors should be 1/8” above the bottom shelf before

fully tightening hinges to post. Use the wrench thickness

as a guide for the bottom gap. Secure hinges in place

with hex key.

Rubber Stops

Attach the rubber stops to the inside of the door

frame where it hits the shelf pegs.

Attach Doors

Note: The hinge can be separated by pulling the
black tab and pulling apart the hinge from the
hinge base. Separated hinges snap back together.

PULL

SHELF

PEG

Doc No. 501-092/v6.18 345 -3 of 4

Summary of Contents for SYNERGY 345 Quad

Page 1: ...s Ltd Synergy System Patented Limited Warranty For five full years Salamander Designs Ltd will repair or replace at our option any product defective in materials or craftsmanship Salamander Designs Lt...

Page 2: ...s to Bottom Shelf WARNING Tighten by screwing the leveler foot NOT the post 2 Add Shelf Pegs Door Hinges C Heavy Duty Bracket The heavy duty brackets will be used to supoort the double width shelf B D...

Page 3: ...should be 1 8 above the bottom shelf before fully tightening hinges to post Use the wrench thickness as a guide for the bottom gap Secure hinges in place with hex key C Rubber Stops Attach the rubber...

Page 4: ...place with thumb nuts 2X 4X 4X 2X 4X REAR Attach Rear Panels A Placing Adjusting Shelves Place shelves from the bottom up Angle the shelf in between the front post and set on top of shelf pegs Use th...