Surface Hub Battery Storage Case
501-738 v11.21 page 5 of 8
1.
Determine Drill Locations
Place the 11 x 17 drilling template provided over the Stand Cubby Cover and align the two horizontal lines
on the template shown at left with the top and bottom edges of the slot in the Cubby Cover.
Align the left edge of the template with the inside edge of the Cubby Cover slot.
Align the top long edge of the template with the line created where the Cubby meets the
Upper Rear Cover.
Tape the template to the Cubby Cover and drill two clearance holes for 1/4-20 holes with the
drill bit provided at the center of the “X” locations.
2.
Attach Brackets
Attach the two L Brackets loosely (but tight enough to maintain the orientation shown) through
the drilled holes using the two 1/4-20 x 1/2” Button Head Screws into the two 1/4-20 Nylon Lock Nuts.
1/4-20 x 1/2” BUTTON HEAD SCREW (2x)
L BRACKET (2x)
1/4-20 NYLON
LOCK NUT (2x)
CUBBY COVER SLOT
UPPER REAR COVER
CUBBY COVER
Installing on Fixed Height, Mobile Stand
Summary of Contents for FPSA/MSB
Page 8: ......
