9
- EN
Ending the program through
canceling
In order to cancel the selected program, press
the “Start/Pause/Cancel” button for 3 seconds.
The machine starts to discharge the water.
“Wash” and “Program Finished” lights will light
up. “Start/Pause/Cancel” and “Wash” lights will
go off after discharging process is over and the
“Lid” light will start flashing. “Lid” lamp will light
up continuously when the door is unlocked.
If the program is cancelled in the middle of
the process, “Wash” and “Program Finished”
lights will light up. The machine can drain all the
water or can take in water for 3 times at most
to cool down the clothes and complete draining
process. When the water discharging process
is completed, the “Wash” light will go off, the
“Program Finished” light will light up and the
“Lid” light will continuously flash until the door is
unlocked.
End of program
The “Program Finished” lamp on the program
follow-up indicator will light up when the
program comes to an end. The lid is unlocked 2
minutes later, the “Program Finished” and “Lid”
lamps will light up continuously. The machine is
now ready for a second cycle.
If any key is pressed when the machine is at
the end of the program or if the position of
the selection knob is changed, the “Program
Finished” light will go off and only the “Lid” lamp
will remain as lit. If the door is still locked, the
“Lid” light will continue flashing until the door is
unlocked.
Press the “On/Off” button to shut down the
machine.
5 Maintenance and cleaning
Detergent Drawer
Remove any powder residue buildup in the
drawer. To do this;
1. Press the dotted point on the siphon in the
softener compartment and pull towards you
until the compartment is removed from the
machine.
C
If more than a normal amount of water
and softener mixture starts to gather in the
softener compartment, the siphon must be
cleaned.
2. Wash the dispenser drawer and the
siphon with plenty of lukewarm water in a
washbasin.
3. Replace the drawer into its housing after
cleaning. Check if the siphon is in its original
location.
Inlet water filters
There is a filter at the end of each water intake
valve at the back side of the machine and also
at the end of each water intake hose where they
are connected to the tap. These filters prevent
the foreign substances and dirt in the water to
enter into the machine. Filters should be cleaned
as they get dirty.
• Close the taps.
• Remove the nuts of the water intake hoses to
clean the surfaces of the filters on the water
intake valves with an appropriate brush.
• If the filters are very dirty, you can pull them
out by means of pliers and clean them.
• Take out the filters on the flat ends of the
water intake hoses together with the gaskets
and clean thoroughly under streaming water.
• Replace the gaskets and filters carefully to
their places and tighten the hose nuts by
hand.
Draining any remaining water and
cleaning the pump filter
Your product is equipped with a filter system
which ensures a cleaner water discharge that
