PRIOR START-UP OF THE APPLIANCE
When it is unpacked, check that the following parts are with
the oven:
• Instructions and Installation Manual
• oven grid
• 1 tray
• Screws and stoppers for fitting the appliance in the housing
GRILLE
To install the grille into the oven, the stopper of the grille
must be in the rear part of the cavity, and in upright
position as same as the below figure.
FITTING THE APPLIANCE (see Fig. 5)
These appliances are classified as Class I.
The earth is obligatory as provided for by law. The manufactu-
rer declines all liability in the event that the accident preven-
tion rules have not been followed.
IMPORTANT
The adjacent piece or furniture or cupboard and all the mate-
rials used in the installation must resist a minimum temperatu-
re increase of 85 ºC above the ambient temperature during use
of the appliance.
Certain types of vinyl or laminated kitchen furniture are parti-
cularly susceptible to damage due to decolouration at tempe-
ratures below those indicated.
If the appliance is installed without paying attention to this
temperature limit or if it is placed less than 4 mm from the adja-
cent cupboards, liability will belong to the owner.
INSTALLATION NOTES
1. The oven has to be installed in a standard gap of 600mm, as
indicated in Fig. 5, whether under a hob or in a column.
2. On inserting the oven in a column, it is essential in order to
ensure there is enough ventilation, to remove the rear panel
of the furniture and have an opening of at least 85-90mm as
indicated in Fig. 5.
3. Check that the oven has been fixed securely in the housing.
Fixing the oven into the cupboard is done using 4 screws “A”
Fig.5. One in each corner of the oven door frame.
Fig. 5: Installation distanced for simple electric ovens of 60 cms
wide (the shape of the upper casing may vary) and
attachment to the cupboard.
BUILT IN DIMENSION FOR OVEN WITH DOOR THICKNESS OF
26mm (dim A)
(dim A)
BUILT IN DIMENSION FOR OVEN WITH DOOR THICKNESS OF
20mm (dim B)
(dim B)
Summary of Contents for HORNO
Page 1: ......
