12
After every use, immediately rinse out the sprayer by
spraying clean water for 2 minutes through the pump to flush any
residual chemicals to prevent corrosion or clogs, and make sure no any
liquid left in the pump and the tubing, then remove the battery.
Attaching the shoulder strap
See Figure 11.
Reference the Figure 3 to attach the shoulder strap if needed.
Installing/removing battery pack
See Figure 12.
To insert battery, align battery and gently slide battery pack into the
device until it locks into position. Do not force.
To remove battery pack from the device, press and hold the release
button and gently pull backward.
Adjusting the flow rate
See Figures 10.
The flow rate can be adjustable from the minimum to maximum by rotating
the Flow Rate Control Knob from the initial “OFF-ON” position to the
limiting “Max” position.
Rotate clockwise the flow rate control knob to get the device ready to
run when you hear a “click”, and steadily increase the flow rate when
continuously rotating clockwise the flow rate control knob.
Rotate counterclockwise the flow rate control knob to steadily
decrease the flow rate and turn off the sprayer when rotating back to
the “OFF-ON” position.
Adjusting the spraying patterns
See Figure 9.
The adjustable nozzles can be switched among different spraying patterns.
Loosen the nozzle tip for a stream pattern.
Tighten the nozzle tip for a mist pattern.
Spraying chemicals
See Figures 13-14.
According to the section of “
Sprayer Configurations
”, choose the
appropriate nozzle and lance per your spraying work and attach it to
the spray gun.
