STEP 2:
Separate the switch base from the knob operator by unlocking lever (1).
STEP 3:
Strip AC wires back about 3/8”. Route wires through knockout/strain relief.
STEP 4:
Connect ground wire to ground terminal (1).
STEP 5:
Connect AC line wires to the switch. Follow local electrical codes for proper
AC wire routing: 1 and 2 are neutral, 3 and 4 are hot.
STEP 6:
Attach the switch back to the AC cover and reattach the AC cover into the
Control Panel.
sageglass.com/resources
STEP 1:
Loosen screws (1) and AC cover (2) (do not need to remove screws). Slide AC
cover towards controllers and then remove to gain access to switch and
ground terminal. Remove dust cap over controllers (not shown).
CONTROL PANEL WIRING - AC CIRCUIT
Only a qualified electrician can install the AC side of the panel.
FIGURE 6: AC CONNECTIONS
1
FIGURE 7: SWITCH CONNECTIONS
1
3
2
4
FIGURE 5: SWITCH DISCONNECTING
1
FIGURE 4: AC COVER REMOVAL
1
2
