29
60% and silence the alarm, the alarm icon will continue to flash until the
humidity falls below 56%, at which point, the alarm will reset and must
increase above 60% to activate again.
8.4 Alarm and Key Beeper ON/OFF
Press any button to silence the alarm sound.
In normal mode, press and hold the
ALARM
key for three seconds to
toggle the
BZ ON
(beeper on) or
BZ OFF
(beeper off) depending on the
current setting.
Display console return to normal mode without any operation in three
seconds.
9. Optional Calibration Mode
Note:
The calibrated value can only be adjusted on the display
console.The outdoor remote sensor(s) always displays the un-calibrated or
measured value.
Note:
The measured humidity range is between 10% and 99%.
Humidity cannot be accurately measured outside of this range. Thus, the
humidity cannot be calibrated below 10% or above 99%.
The purpose of calibration is to fine tune or correct for any sensor error
associated with the devices margin of error. The measurement can be
adjusted from the console to calibrate to a known source.
Calibration is only useful if you have a known calibrated source you can
compare it against, and is optional. This section discusses practices,
procedures and sources for sensor calibration to reduce manufacturing and