Chapter 2: Operation
General use and navigation
13
22222
Oper
ati
o
n
If the GPS was present and then disappears a warning appears in the display
after 10 minutes, then you can enter the position and UTC time manually as
described above.
Channel information always available in the display
For some functions and for the setup pages,
the channel and radiotelephony information
has moved to the bottom section of the
display. You can change frequencies whenever
the frequencies are displayed.
If
PTT
is pressed the radio transmits on the
displayed frequency on which the radio is
tuned into for communication. If a signal is
received, it is received on the displayed
frequency.
Engagement status
The radio is engaged when an active DSC-initiated communication is ongoing,
or communication is active on non-DSC initiated MF/HF operation:
•
A new channel is selected
•
PTT is pressed
•
Voice signal is received (if squelch is enabled)
The engagement state is used to prohibit incoming DSC calls from taking over
control of the transmitter channel, disrupting ongoing communication.
When the radio is engaged in communication not initiated by DSC, this is
indicated with the symbol
in the display. Engagement will automatically
time-out on inactivity, after an inactivity time specified in
DSC setup
on
page 42.
To terminate the engagement immediately press the soft key
QUIT
.
Scan Hang Time: OFF
EXIT
RADIO SETUP
SSB
SQ
4357.0 RX
4065.0 TX
Scan Resume: OFF
Scan Mode: VOICE
External PTT: DISABLED
(Example: Radio setup)