97-147768-A
SAILOR 6300B MF/HF
Service Interface User Manual
12
3.2.2
CONFIG
The
CONFIG
tab contains two side-bar buttons and each are described in turn:
Figure 9: CONFIG tab – Configuration side-bar page.
Configuration
Description
MMSI
Enter or change the MMSI number of the radio.
Call ID or MMSI
This is the 5-digit Telex call id. If there is no 5-digit call id
allocated you can use the 9-digit MMSI or leave the field empty.
Abbreviated ID
This is used for Telex identification and is part of the answer
back string. The abbreviated ID is usually 4 ASCII letters, e.g.
‘abcd’.
Slave delay
This is the slave delay used during Telex ARQ calls. Default value
is 10.
ATU available?
Deselect this tag if the system does not have an ATU (Antenna
Tuning Unit) connected. The option is used for dedicated
antenna on specific frequency or dummy load.
Note: Wrong selection may damage the ATU.
PSU Monitor enabled
If the radio’s power supply is a SAILOR 6081 you can enable the
Power Supply Monitor in the radio.
Primary station
Select this tag if you want this radio to have priority over a
duplicate MF/HF installation.
