Sailor 6215 VHF DSC, User & Installation Manual

Page: 31 / 104

Chapter 2: Operation
Radio setup 21
22222
Operation
Radio setup
In the RADIO SETUP you set scan and watch mode, select the channel table
and can set and view the ATIS code. To change a setting in the
RADIO SETUP ,
do as follows:
1. Press the soft key SETUP . If it is not in the display, press the soft key MORE
until SETUP appears.
2. Press the arrow soft key or to advance to RADIO SETUP .
3. Turn the selector wheel knob to go to a setting, then press
the selector wheel knob to change the setting.
4. Press EXIT to return to normal radio operation.
Para-
meter
Description
Scan
Hang
Time Scan hang time, in seconds on an active receiving working channel.
The time is measured from the signal is detected. The radio remains
on the channel for the set time interval, if a signal was detected.
OFF : Resumes scanning when signal disappears (default)
4, 6, 8, 10: Hang time in seconds.
Scan/
watch
Resume Scan resume time, in seconds. When the programmed time of
inactivity has elapsed, and when watch/scan has been aborted using
a press on PTT, or after power-up, scan or watch is resumed.
OFF : Automatic resume is deactivated (default)
3, 6, 10, 15, 20, 25, 30: Resume time in seconds.
Watch
Mode DUAL : Dual watch monitoring the working channel and the priority
channel (channel 16, default for international channels).
TRIPLE : Triple watch. The working channel is watched with the
priority channel (channel 16) and the programmed call channel (if
any, otherwise dual watch).