4
Electrical supply
This equipment is designed for use with a power supply source of 12-24 Vdc. The application of any other
power supply may result in permanent damage to the equipment.
It’s the installers responsibility to ensure the diameter of the cables from the battery to the switching panel and
from the switching panel to the SAILMON products is sufficient.
For any questions contact Sailmon support at [email protected]
•
Avoid excessive voltage drop due to improper cable diameter.
•
Cut the cable to the correct length.
•
Do not make rings of excessive cable inside the switching panel or elsewhere.
Best efficiency and lowest battery consumption is achieved when optimizing cable length to a
minimum.
THE MINIMUM VOLTAGE ON THE MODEL | E4 CONNECTOR MUST NOT FALL BELOW 9.0 VOLTS. UNDER
VOLTAGE WILL CAUSE SYSTEM RESET AND SYSTEM INSTABILITY.
Large currents due to switching of electrical winches or other high power devices will cause under voltages for a
short time. Model E4 will handle this short-term voltage drop if the voltage stays well above 6.5 Volts. A voltage
below 6.5 Volts will result in immediate reset and reboot.
Model | E4 Installation guide 1.0
copyright SAILMON BV 2016
16-11-2016
ALWAYS PUT A FUSE BETWEEN POWER SUPPLY AND SAILMON DEVICE
