Operation
PCD7.D250
Page 5-4
SAIA-Burgess Electronics Ltd.
(D25-05-E.DOC)
26/770 E1
5.3 Setup / Test mode
This mode is entered by pressing
Shift + i
on the ..D250 keyboard.
Setup/Test mode can be entered when the ..D250 on or off line, all data
received from the host is ignored until the mode is exited. During
Setup/Test mode the green no. 8 LED flashes.
Pressing the up or down arrow key steps through the Setup/Test mode
menu:
Setup mode
Configures the ..D250
Default setup
Restores factory default setup
Demo display
Demonstration display
Hardware tests
Runs hardware tests
Display test
Tests the LCD display
Keybord test
Tests the keyboard
LED test
Tests the LEDs
Once the desired menu item is selected, pressing
“Enter“,
the chosen
setup parameters will be loaded permanently into the EEPROM, or the
corresponding test executed. To exit Setup/Test mode, press
“Quit”
or
“Esc”
.
During Setup/Test mode no. 8 LED flashes.
Note:
If the host computer is sending data to the ..D250
when the operator enters Setup/Test mode,
omission of handshaking brings a risk of data loss
or modification.
Prompt text
Scrolling menu
