Sahara Presentation Systems Plc
Williams House, Hailey Road, Erith Kent DA18 4AA
INSTALLATION GUIDE
1. Screw one of the speaker security brackets to the top of each speaker in the pre-
drilled holes provided
2. Select a suitable position for each of the speaker either side of the Interactive
whiteboard.
3. Fix one of the wall mounting screws into a suitable wall plug in the wall in a position
so that the speaker can be hung on this screw using the central “keyhole” wall mount.
Hang the speaker unit on this fixing and mark a hole position on the wall for the
position of the top speaker security bracket.
4. Drill and install a suitable wall plug for the top security bracket.
5.
Hang the speakers using the central “Keyhole” wall mount and secure the speaker to
the wall with the screws provided into the top wall plug position.
6. Connect the 10m speaker cable provided into the active speaker using the RCA
connector in the base of the Active speaker. Measure and cut the raw end of the
cable to the length required to join the passive speaker to the amplifier. Strip off 7mm
of insulation from the cut end and insert into the speaker connections on the passive
speaker
7. Connect the PC Audio cables with 3.5 mm mini jack connectors into the base of the
active speaker unit and into the audio sources (or cable termination box if used)
8. Connect the USB cable into the base of the active speaker unit and into the PC or
Notebook USB ports (or cable termination box if used)
9. Connect the Interactive Whiteboard USB cable into the USB socket in the amplifier
base panel (if this is the way you wish to connect the whiteboard to the PC/notebook)
10. Check that both the on/off switch and the Volume control on the active speaker are
switched off. Plug the power cable to the mains supply and switch the supply on.
11. Follow the Operating Instructions below