ENGLISH
Do not use corrosive or abrasive products.
Mix, prepare and filter the product to be applied
in accordance with
the manufacturer’s instructions, ensuring that any foreign bodies are
prevented from spoiling the quality of finish and application. Should
there be any doubt relating to the purity of the product, its composition,
etc., please contact your supplier.
Control the
viscosity of the product
to be applied with the SAGOLA Vis-
cosimeter - Código 56418001
08. Functional description of the unit
The
Turbo 3000 PRO
is connected to the mains and once it has been
switched
on it starts suc-
king in air which through its
filters
accesses the inside of the turbine from which it is channelled
and
projected outwards
at very low pressure.
The
Turbo 3000 PRO
unit is fitted with an
air hose
with a
quick plug
that connects the turbine to
the
SAGOLA 455
gun out of which air flows continuously.
With the unit operating, when the
trigger
on the gun
is pulled
, the
product
to be
sprayed
is sucked up.
The entire equipment has a
throttle connector hose
to the gun, which alows the
volume of air
.
09. Start-up
Before starting it up
and especially after each cleaning and/or repair procedure, you must
check
that the
hoses
are technically
suited
for the technical features of the equipment and the work task
to be carried out, in addition to being
flexible
and
airtight
(without leaks). Faulty parts must be
replaced or repaired as appropriate.
Check
the condition of the
air inlet filters
before starting each work task (they must be completely
clean).
Check
the
voltage of the mains supply
the equipment is to be connected to.
Check the grounding
of all of the equipment. If you need to use an extension cord, ensure that the
cable has an adequate section and that it is grounded.
Check
that the equipment is located in a place with a perimeter distance of at least 30 cm, away
from
any element that may hinder the suction of air
by the equipment. The omission of this re-
commendation may cause breakdowns.
Turn
the equipment on with the
switch
to
start
it up (
see Fig.1
).
Keep the equipment
operating empty
for
a
few seconds before starting
the work
task to
heat
up the
air
.
Use the regulator
on the
hose connec-
tor
to adjust the atomising
air flow
to the
needs of the work task to be carried out
(
see Fig.2
).
Turn off
the equipment with the
switch
,
when equipment is not in use.
It does not
disconnect automatically
.
(
see Fig.1
).
18/19
Ford Nº4
Fig.01
Fig.02
Summary of Contents for TURBO 3300 PRO
Page 2: ...ESPA OL an Elcometer company...
Page 14: ...ENGLISH an Elcometer company...
Page 26: ...PORTUGU S an Elcometer company...
