Sagi KP12G1M, Use And Installation Manual

Page: 92 / 189

GB
22
WORKING IRREGULARITIES
In case of working irregularities, before to call the technical service in zone verify that:
−
the main switch is lighting and the current is present;
−
the regulated temperature is the wished one;
−
that the door is perfectly closed;
−
the machine is not near heat sources;
−
the condenser is clean and the fan works regularly;
−
an excess of hoarfrost does not cover the evaporating pannel.
In case of negative result, contact the nearest service centre indicating the model and the
serial number shown on the rating placed on the appliance instrument panel.
USAGE INTERRUPTIONS
In case of longer inactivity of the refrigerator and for maintaining it in the best state act as
following:
- set the general cut-out in OFF position.
- remove the plug from the socket.
- empty the refrigerator and clean it as described In the chapter "CLEANING".
- let the door open to avold the forming of bad smell.
MALFUNCTIONING
Malfunctioning during operation is often due to banal causes , whitch may nearly all be
resolved without the help of a specialised technician. Consequently, before getting in touch
with a service centre, check the following:
PROBLEM POSSIBLE CAUSES
The appliance does not start Check that the plug is properly inserted into the socket.
Check that there is voltage at the socket
The internal temperature is too
high Check the electronic card adjustment
Check for a heat source in the vicinity
Check that the door closes properly
The appliance is excessively
noisy Check that the appliance is standing level. A lopsided
appliance could set off vibrations
Check that the appliance is not touching other appliances
or parts which could resonate
Some condensation is
produced on the appliance Room humidity is very high
The door is not closed properly
Upon completion of the above checks, if the fault persists, contact an authorised service
centre. Always indicate:
•
the nature of the fault
•
the model and the serial number of the unit can be found on the electrical specifications
plaque, located on the u
nit’s instrument panel.