3
R
ECOMMENDATIONS
AND
SAFETY
INSTRUCTIONS
Do not install your Wi-Fi IP Radio in a humid room (bathroom, laundry, kitchen, etc.), or within
1.50 m of a tap or water source, or outside. Your Wi-Fi IP Radio should be used at an ambient
temperature of between 15 °C and 35 °C for optimum sound results.
Do not set up your Wi-Fi IP Radio in a dusty environment as dust deposits might adversely
affect the sound quality.
Avoid objects or liquids getting into the unit.
Unplug the power lead if the unit will not be used for a long period.
Do not handle your AC cord with wet hands. if liquid spills on your product, unplug immediately
and contact your dealer for cleaning instructions.
Only the power supply provided with the Wi-Fi IP Radio should be used. Connect this to the
mains in accordance with the installation instructions in this user guide and the information on
the identification label affixed to the power supply (voltage, current, mains frequency). As a
precaution, in case of danger, the mains adapters act as a disconnecting mechanism for the
230 V power supply. They should be placed near the device and should be easily accessible.
Do not attempt to remove any screws or open the unit. No user serviceable parts are inside.
The length of the ethernet and USB cables used on this product shall not exceed 3m.
Do not connect your Wi-Fi IP radio to an Ethernet Network leading outside your building. TThis
device must only be connected to an Ethernet Network inside your building.
This terminal was designed for private use inside a building (CPE customer premises
equipment) in the European Free Trade association (EFTA). It has been tested in accordance
with the technical provisions for radio equipment (EN 300328).
The radio frequency bands authorized for Wireless transmission depend on national
regulations.
The installation of this terminal operating in the 2.4 GHz band is covered by the European
recommendation ERC 70-03.
Before use, make sure that the gateway with which you establish a wireless connection from
your terminal is set up in accordance with this regulation and with the national regulations
where it is used.
Sagem Communications accepts no liability if the regulations in force on the installation site
are not complied with.
Only the antennas provided with the Wi-Fi IP radio should be used.
Some sensitive medical equipment and safety equipment may be affected by the radio-
frequency transmissions of your radio. In all cases, we ask that you respect the safety
recommendations.
The device shall not permanently be installed or used closer than 20cm from the human body.
The CE marking certifies that the product meets the essential requirements of Directive 1999/
5/CE of the European Parliament and of the Council pertaining to microwave radio equipment
and telecommunication terminal equipment, for the safety and health of users, for
electromagnetic interference. Furthermore, it efficiently uses the frequency spectrum
attributed to ground and spatial communication to prevent damaging interference.
The declaration of compliance may be looked up on the
www.sagem.com
site, section
"
support
" or can be obtained from the following address:
Sagem Communications
- Customer relations department
4 rue du petit albi - 95800 Cergy Saint-Christophe -France
!
QG Radio IP EN.book Page 3 Vendredi, 7. décembre 2007 10:37 10