Sage Nutri Juicer Cold BJE430, Quick Manual

Page: 11 / 60

11
EN
Motor appears to
stall when juicing
• Wet pulp can build up under the juicer cover and stall the juicer if the juicer
is used excessively without cleaning. If this occurs, disassemble and follow
the cleaning instructions to clean the filter bowl surround, the stainless steel
filter basket and the juicer cover.
• The juicer will automatically stop operating if either too much food is being
processed at one time or the pieces are not small enough. Try trimming the
food or cutting into smaller pieces of even size and processing a smaller
amount per batch. To continue juicing, reset the juicer by turning the juicer
OFF and back ON.
• Allow the motor to reach full speed before putting ingredients in the chute.
Pressing ingredients down before the juicer reaches full speed can cause
the motor to stall or overload. Use gentle to moderate pressure on the pusher.
Lower pressure produces a better juice yield.
• Hard fruit and vegetables will put excess strain onto the motor if a low speed
is selected. Refer to the juicing guide to determine the correct speed for the
fruit and vegetables selected for juicing.
Unit stops &
overload protection
LED flashes
• This indicates the motor speed is slowed down to an inefficient level. This
may be caused by too heavy pushing force on the pusher or too much pulp
sticking onto the lid or in the pulp bin. Using moderate pushing force on the
food pusher or regularly cleaning the lid and pulp bin can prevent this situation
from happening.
Overload
Protection
LED is on
• This indicates motor overload protection is activated. To reset the unit,
unplug the unit from power and let the motor cool down for 10 to 15 minutes,
and plug the power on again.