3.Send to cutter
Direct cutting, mainly used for cutting blank
materials
4.Vinyl Spooler
ARMS cutting,mainly used for file with marks.
(open Barcode Controller after,you will find ARMS
cutting interface)
On Vinyl Spooler
5.Blade offset
6.Overcut
Blade offset
Blade
Machine default is 0.3mm, but sometimes depending on
the thickness of the material, need to test and adjust.
If the corners of the squares are rounded, the offset setting is too low.
Conversely, if the corners are too pointed, the offset setting is too high.
Machine default is 2 mm, but sometimes depending on
the thickness of the material, need to test and adjust.
Overcut
Cutting surface
Backing sheet
Blade
The general starting point and
end point in cutting junction,
need to change the parameters,
mainly used for cutting thickness
of ≥0.2 materials
