3.3 Installing Tools
Step1.....Loosen the tool holder screw sufficiently to enable a cutter
pen to be inserted up to its flange.
Step2
Step3
Step2.....Push the cutter pen all the way into the holder until it contacts
the upper part of the tool holder.
Step3..... Tighten screw.
When you push the tool holder up with your fingers,take care not to touch
the cutter blade.
WARNING
3.4 Turning on the cutter
1.Securely plug the other end of the power cord into an electrical outlet of the
specified voltage.
2.Turn on the power.
3.The green power lamp on the control panel will light, and the Y bar and
carriage will start to move as shown in the figure below. These operations
are part of the initialization process.
