SAFWAY Huennebeck MANTO G3, User Manual

Page: 53 / 224

53
Unless stated otherwise, all dimensions are given in mm.
MANTO®
4.3 MANTO panels G3
MANTO panels G3 can be identified by the following characteristics:
• No reinforcement plates on the inner side of the long edge profiles near the tie hole
• Tie position on the long edge profile with smaller holes above and below the tie hole,
for the single-side operated anchors
• Bracing between ribs and/or between ribs and smaller edge profiles (in most panels).
• Holes Ø 22 in the edge profiles.
1200 1050 900 750 700 650 600 550 450 300 350 350 750
3300
2700 2700
1200
1200 1050 900 750 700 650 600 550 450 300 350 1200 1050 900 750 700 650 600 550 450 300 350 1200 1050 900 750 700 650 600 550 450 300 350 350 750
1200 1050 900 750 600 450 300 350
A B
750
C
A - Panels; B - Corner panels; C - Multipurpose panels;
D - Extension panels.
2400
D
1200 1050 900 750 700 650 600 550 450 300 350 350 750
1200
900
600
For Safe Working Loads for MANTO panels, refer to page 217.