User Manual of HD-TVI Speed Dome
4
Chapter 2
Getting Started
2.1
Power-up Action
After the speed dome is power-on, it will perform a series of self-test actions. It runs the pan
checking firstly, then the tilt checking and the camera checking at last. After the power-up actions,
the system information will be displayed for 2 minutes on the live view screen as shown below.
XX-XXXXX-XX
SN XXXXXXXX
ADDRESS 0
COM FORMAT 2400,8,1
PROTOCOL SELF ADAPTIVE
FIRMWARE X.XX
HARDWARE X.XX
BUILD DATE XX XX XX
Figure 2-1
System Information
Table 2-1
Descriptions of the System Information
System Info
Description
SN
The serial No. of the speed dome, which is unique.
ADDRESS
The default communication address of the speed dome.
COM Format
The communication settings of the speed dome, including baudrate
(2400 by default), data bit (8 by default) and stop bit (1 by default)
digit).
PROTOCOL
It is for the communication with other devices.
FIRMWARE
The version of the firmware.
HARDWARE
The version of the hardware.
BUILD DATE
The date when the program of the software is compiled.
⚫
You have to configure the address and the baudrate for the speed dome the same as those in
the control devices.
⚫
The speed dome is self-adaptive to the PELCO-D, PELCO-P, and PRIVATE-Code protocols.
2.2
Basic Operations
You can operate the speed dome using a control device, including the control keyboard, DVR, DVS,
