SAFIRE 3200B AND 3800A FUEL OIL HEATER
INSTALLATION, OPERATION AND MAINTENANCE
1.5.1
30L TANK
(475x315x295mm)
Can be used either upright or horizontally.
The heater comes with tank connection parts (filter, vacuum hose, air hose and
threaded ring).
The tank must be placed under the heater, e.g. in the basement of the house.
If the fuel line and wiring of the pump have to be led through the structures, they
must be protected with e.g. electric plastic installation pipe. For trought the floor
or wall, drill approx. 10 mm hole for fuel line and wiring.
If you want to install the tank and pump inside, select a place where filling the
tank or exchanging tanks does not cause inconvenience.
1.5.3
TANK CONNECTION
1.5.4
PUMP
The pump is installed close to the tank above the liquid surface in an upright position with the
suction side down. The maximum vertical drop from the bottom of the heater to the tank is
approx. 2 metres.
1.6
ELECTRICAL INSTALLATION
(see wiring diagram on the back cover)
.
1. The electricity should preferably be input directly from the battery (
+ red, - yellow
). Protect
the wiring with a 20 A fuse (the electronics of the heater are protected by a 15 A main fuse).
If you need to use longer wires, remember to replace the original wiring with thicker ones so
that the cross-sectional area of the wires in mm2 corresponds with the length of the wires in
metres, e.g. the area of two 10 metre wires should be at least 10 mm2.
In this case, cut the original wires at a suitable length behind the heater and attach thicker
wires with a suitable connecting piece.
Be careful not to
connect the wires to the battery with reverse polarity (in this case, the
fuse of the electronics will blow).
2. The wires of the pump are connected to the middle pins of the X10 connector. The wires
cannot be connected the wrong way round.
3. In thermostat installations the sensor is connected to the empty pins of the X10 connector
(see wiring diagram). The wires can be extended and they cannot be connected the wrong
way round.
4. A Gsm- remote start-up device is connected behind the control panel to the X9 connector of
the heater circuit board.
When using automatic start-up, the heater switch should be in the AUTO position.
The circuit board of the heater has a selection connector for the input voltage of the RJ
connector. It should be in the position 2-3 when a 1287 remote control device is used (this is
the factory default setting) and in position 1-2 if a Genius control board is used.
December 2014
SF-LÄMMITIN OY Tilhenkatu 1 20610 Turku Finland Tel./Fax 02-2443282
1. AIR HOSE
2. FUEL HOSE
3. THREADED RING
4. FILTER
5. PROTECTION
