Introduction To The Components
13
Emergency Stop Locations
There are multiple emergency stop systems in
place on the machines. On the 43” x 75” belt
sander there is one on the front of the table. See
Fig. 19. On the 37” x 60” machine, this stop is
located just above the opening to the sanding head
on the cabinet. See Fig. 18. The other emergency
stop on both machines is a mushroom-shaped
button located on the front of the control panel.
Use the stops located on the outside of the
machine in any emergency situation where the
machine needs to be stopped immediately.
There are also two emergency stops inside the
cabinet that will automatically shut the machine
down in the event that the abrasive sanding belt
overtracks to the left or right hand side of the
machine. See Fig. 20. Inside the belt loading door
there is a safety switch which requires the door to
be closed before operation. The other emergency
stops must be pressed to shut the machine down.
There is also an emergency load cut off on 3
phase machines.
Emergency
Stop Button
Emergency Stop
Bar
Figure 18: 37
” x 60” Belt Sander Emergency Stops
Emergency
Stop Button
Emergency Stop Arm
Figure 19:
43” x 75” Belt Sander Emergency Stops
Emergency Stop Switch
Emergency Stop
Switch
Figure 20: Automatic Emergency Stop Switches
