Table of Contents
SafetyLink Anchor Handbook Extract
– LadderLinks - Version 11.18
Page 7 of 12
FIXED LADDERLINK
–
METAL ROOF LADDER SUPPORT BRACKET
INSTALLATION FOR METAL ROOFS
–
ON TOP OF ROOF SHEETING
1.
To install the LadderLink simply remove existing hex head roofing screws along the bottom edge of the roof
sheeting at the desired location.
2.
Place the ladder bracket on top of the roof sheeting as shown in the diagram below.
3.
Position the ladder bracket so the rolled section is centred over the gutters front edge.
4.
Once the ladder bracket is in the desired location, re-install the hex head roofing screws through the ladder
bracket, ensure the screws go through the roof sheeting and into the roof batten below.
5.
Ensure that a minimum of three (3) x 12g 65mm roofing screws anchor the ladder bracket to the structure
(recommended to pilot drill holes).
6.
Install an additional two (2) x 8mm Rivets at the top corners 50mm down from the top edge, see below
diagram. This must be completed to prevent rocking of the ladder bracket.