Table of Contents
SafetyLink Anchor Handbook Extract
– LadderLinks - Version 11.18
Page 10 of 12
APPENDIX
–
Diagram 2
–
Anchor Positioning Layout
THIS IS A GUIDE ONLY
All working at heights safety procedures must be complied with when installing SafetyLink anchor points. For more
information refer to your state or territories current legislation, regulations, policies and codes of practices.
IF ANY DOUBT EXISTS WITH THE STRENGTH OF THE STRUCTURE OR ROOF SHEETS AN ENGINEER SHOULD MAKE THE ASSESSMENT.
DURING INSTALLATION YOU MUST BE SAFE AT ALL TIMES.
INSTALLATION MUST BE CARRIED OUT BY, OR UNDER THE SUPERVISION OF A COMPETENT HEIGHT SAFETY INSTALLER.
ACCESS, LAYOUT AND USE OF A SAFETYLINK ANCHOR SYSTEM
SafetyLink anchor points are positioned by calculating the pendulum effect, this limits the likelihood of a
fall past the edge of the roof space. The pendulum effect still applies to a flat roof.
SPACING MUST BE NO GREATER THAN THE RAFTER LENGTH, PLEASE CONTACT YOUR DISTRIBUTOR IF YOU ARE UNSURE.
SAFETYLINK HEIGHT SAFETY SYSTEMS MUST ONLY BE INSTALLED AS PER OUR INSTALLATION GUIDES, TO STRUCTURES AS
SPECIFIED IN THE INSTALLATION MANUAL FOR EACH PRODUCT. SHOULD ANY DOUBT EXIST IN REGARD TO THE STRUCTURES
INTEGRITY AN ENGINEER SHOULD BE
CONSULTED.
A
B
Use of Rope Line from point A to point B
Entry Point
