Operating Instructions
After installing the SD card, Turn the power on
Under the DVR mode, press MODE to switch record/playback, press
enter to confirm the selection
Press and hold the DVR/AV button for 5 sec to switch from single to
quad modes
Press the menu button to adjust the user preferences with power but-
ton to page down
Monitor installation
Monitor Installation
Step 3 Mount video camera as per manufactures instructions. Route camera
cables through equipment/machine being careful not to come into contact with
hot machine parts, moving parts or sharp objects. Find a suit-able opening
through the cab. Try routing the cable along side with other cables or hydraulic
lines. If no holes or
access plates available. Drill a hole through the cab slightly larger than the
camera cable connector. Place a rubber grommet inside the drill hole to protect
the camera cable.
Take notice you may not drill or modify the cab by some manufactures war-
ranty. Also take note that most cabs are ROPS certified and may not allow
holes drilled. Check with the machine manufacture for permission to drill.
Step 4 Connect the male end of the camera cable to the camera. Apply electri-
cal sealant to the connectors if the equipment is used in damp and or salt loca-
tions. (Grote Ultra-seal or equivalent) Tighten by hand the locking ring on the
connector. Do not use pliers to tighten. Slide the waterproof rubber boot over
the connector
Step 5 repeat step 4 for addition cameras
Step 6 Connect the wiring harness
(shown below)
to the monitor cable. (This
may already be connected from the factory. If so, skip to step 7). 13 pin male
plug to the 13 pin monitor female connector. Caution: Align the arrows on both
male and female connectors. Failing to align the arrows will result in broken
pins.
