52
53
1
2
Pull Vehicle Belt Across
Child Restraint
Thread vehicle seat belt
under
pad in front of buckle
strap to the opposite side.
Buckle vehicle belt.
Do not place vehicle belt
over child’s legs.
3.
NOTE:
The buckle
MUST
be in the 1st or 2nd buckle strap
slots when rear-facing. Any slot can be used for
forward-facing.
Locate Locking Clip
Location
Grasp both vehicle belts
together just behind the
latch plate and unbuckle.
NOTE:
If the latch plate ends
up just at the belt path
opening so you cannot
grasp the vehicle belt at the
latch plate, grasp the vehicle belts on the opposite side of the
child restraint, as close to the latch plate as possible. Install
the locking clip on the latch plate end, as close as possible.
Tighten Vehicle Belt
Push down firmly on the
child restraint and while
pulling on the vehicle
shoulder belt to tighten.
4.
5.
Attach Locking Clip
Thread both portions of the
vehicle belt onto the locking
clip, as close to the latch
plate as possible.
6.
Position Locking Clip
Position locking clip about
1 in. (2.5 cm) from vehicle
belt’s latch plate.
7.
Rebuckle Vehicle Belt
8.
9.
Check Vehicle Belt
Tightness
Grasp the child restraint
at the vehicle belt path
with one hand. Push and
pull the child restraint
from side to side, forward
and back. The child
restraint should not move
more than 1 inch.
NOTE:
If it moves more than an inch, redo the steps 5 through
9 again or try another seating location.
Remove the locking clip when the vehicle seat belt is not
being used with a child restraint.
4358-5258 onSide Air 6/4/10 9:49 AM Page 55
Meijer.com