AC Adapter
Operating Your Grow-With-Me Intercom Monitor
Follow these instructions to operate your Grow-With-Me Intercom Monitor. Reference
the illustrations on pages 2 & 3 for the location of all features described in these
instructions.
Baby’s Unit:
For best results, place the Baby’s Unit on a table near the crib or bed. It should be facing
the baby’s head as close to the crib as possible, but out of baby’s reach.
STEP 1 Plug the round end of adapter cord into the jack on the Baby’s base unit, then
plug the the adapter into an electrical outlet . The LED Light on the Base should be
illuminated and solid green and the LED Light on the detachable toddler unit should be
illuminated and a solid green (if fully recharged). LED indicator will be solid red if
toddler unit is recharging.
STEP 2 Remove the battery compartment door on the back of the baby’s Base unit.
Select one of the four channel options. If you experience static or noise interference
select one of the remaining three channels and note your selection on a separate piece of
paper. Replace the Battery compartment door.
STEP 3 As baby grows older and mobile detach portable toddler unit fom Base Unit as
shown.
(LD of hand separting pieces)
STEP 4 Using Child Resistant Clip on back of portable toddler unit, attach to baby’s
clothing as shown.
(LD of hand attaching monitor to clothing)
STEP 5 Portable toddler unit normally blinks green when it is out of its base. After
several hours of continuous use the LED Light on the portable toddler’s unit will blink
red, indicating low battery-needs recharging. Return toddler’s unit to Base Unit. When
reattached and switched ON, LED on portable toddler’s unit will glow solid green. When
Base Unit is switched OFF, LED will change to solid red, indicating recharging in
progress. Overnight recharging is recommended. The portable toddler’s unit may now be
re-separated from the Base Unit and reattached to baby’s clothing.
STEP 6 After sustained use and numerous recharging cycles, the recharge-able batteries
may need to be replaced. Remove screw from Rechargeable Battery Compartment cover
on back of Base Unit; remove cover.
