Fully Recline and Place Child
Restraint in the Back Seat Rear-
Facing
For children between 5-22 lbs
(2.3-10 kg),
the bottom level to ground
line MUST be level to the ground.
40
39
E. Installing Rear-Facing
E-2
Preparing to Install Lower
Anchor Belt Rear-Facing
Pull Pad Off Corners of
Child Restraint
Pull the seat pad off the
front corners of shell.
1.
Routing Lower Anchor
Belt
Insert the hook with adjuster
through the rear-facing belt
path.
2.
Pull Hook Across to
Opposite Side
Reach under pad and pull the
Lower anchor hook across
the shell. Lower anchor belt
MUST
be under pad and in
front of buckle strap.
NOTE:
You must use the
1st or 2nd buckle strap slots
when rear-facing.
3.
1
2
Replace Pad Over
Corners
Make sure the belt is not
twisted.
4.
Store Top Anchorage Hook
(Tether)
Attach the top anchorage hook
(tether) to base as shown. Tighten
tether to remove the slack.
E-3
Install Rear-Facing with
Lower Anchor Belt
1.
Do not use the lower anchor belt along with the vehicle
lap or lap/shoulder belt.
Check lower anchor belt before each use. Use only if the
belt can be tightened properly and securely.
Do not fasten multiple lower anchor hooks on the same
lower anchor bar in the vehicle.
Store the tether hook when used rear facing. Attach the
tether hook to storage attachment and gently tighten to
remove slack.
Failure to follow these warnings can result in serious
injury or death.
Note:
Review your vehicle’s owner
manual for lower anchor belt use.
2.
continued on next page.
