Lift level tool
SAFE 91245
2002-09-05
B.5.1. Insert this
end in to the gun.
B.5.2. Press and hold “SETTING” and press =”ON/OFF”.
When “LOW BATTERY” is lit, release buttons.
Press “SETTING” and the leds will start to blink.
In this mode it is able to check the lift height.
Important! Press the tool completely against the gun then pull the trigger.
Otherwise the gun may be damaged!
Important! Hold the gun so the tool is horizontal.
B.5.3. The lift level is calibrated when the inner rod, made
of brass, on the tool is in same level as the outer plastic
sleeve. Tolerance ±0,2 mm.
If the gun is not calibrated see seperate instruction for
adjusting of the gun.
MAINTENANCE
IMPORTANT!
The normal liftheight is 2mm.
This is very important for the arc and energy amount.
Too high liftheight increase the risk of a “coldbrazing”,
too low liftheight reduce the time and increase misfi res.
12
