MAINTENANCE
Periodically maintenance of S15 automatic gun
IN-039-01
B.1. Check that all cables and lugs are without damages
and properly tighten in gun and unit.
B.2. Check that the right pinholder is fi tted in the gun.
Make sure that pinholder is tight to the gun, use spanners as the
fi gure shows. Otherwise a spark can destroy the axle.
Use one spanner 8mm and one 10mm for 8-9,5 mm and M8 pinholders.
Two pcs of spanner 10mm for M10 and M12 pinholders.
Make sure, never twist the axle when mounting the pinholder!
The brazing pin shouldn´t go too loose in the pinholder,
when it does push together with your fi ngers.
Otherwise you can have a contact fault or a spark can arise.
B.3. Check that the ringholder is the
right type. You can dismount it by hand
otherwise adjust with the small screw on
the side of the gun.
B.4. Load the gun with a 8mm pin and
ferrule. Check that the axle move easily
with the pin and ferrule fi tted when moving
back and forward.
If not, change either pinholder or ringholder.
If it still doesn´t move easily the axle is
damaged and must be sent for repair.
SAFE No.
For brazing pin
Mark
9211
8-9,5 mm
A
9213
M8 threaded
B
9215
M10 threaded
C
9217
M12 threaded
D
11
