LED Display information
1.
power
Connect the Household power,
Turn on the power switch, Green light
。
2.
battery recovery
if the battery voltage is too low, Yellow light indicatior flas
h, first to recovery-charging(Max Amp 1A), it will last for one hour,if the battery
voltage can be recovered to be above 8.5V(12V battery), 4.5V(6V battery), the
charging light will turn on, recovery light will be off, recovery-charging will turn
to normal charging. If it can not be recovered to normal voltage, dead battery
red light will be on, recovery light will be off.
3.
charging
When charging, yellow light will be on
4.
charged
When charged, green light will be on, disconncet the battery connection, light will
be off.
5.
wrong connectlon
when the
Red/black clamp is circuit short or the battery is
connected reversely, or the charger is connected to 12V battery under the condition of 6V, red
light will flash.
6.
overload
If the internal temperature is above 80
℃
, the red light will be on, it can be
charged, if above 100
℃
, the output will be cut, charging light will be off, this red light will
be on.
7.
dead battery
If the battery can not reach the preset voltage
above 8.5V(12V battery),
4.5V(6V battery),
after 1 hour recovery, the recovery will stop
，
red light will be on to
judge it as a dead battery.
Warning:
When charging, according to the battery voltage, select the charger charging
voltage, so that the charger output voltage to meet the requirements of the battery
requirements, so as not to use the wrong voltage charge battery
Ammeter display battery status
The ammeter indicates the battery capacity by the percentage of battery capacity.
0 -6A Charging current be appropriate for 6-75 AH
Lead-acid
battery
Charging Procession
Connect the battery charger to the mains power (120V AC):
Connecting 120V AC power supply, the power LED will indicate. If the output is in a short-circuit
situation, the LED will indicate “Fault”
,
, please solve the problem.
Connecting the battery charger to your Battery
Connect the red clamp from the charger to the positive (+) battery terminal. The Black clamp from the
charger to the negative (-
) battery terminal. (The “Fault” LED will indicate if output reverse polarity
connection, please re-connect )
Start the charging
Connect AC plug to 120V power correctly, Select charging voltage 6v or 12v battery (If you are not
sure the battery type pl
ease read the battery’s rating label first). Then connect both of clamps with
battery terminals, turn on the power switch and began charging, final select appropriate current.
Floating charging function
