24
© 2015 SafeLine and all the SafeLine products and accessories are copyrighted by law.
MX3 v1.06 EN
Service
Emergency
button NO
Emergency
button NC
TROUBLESHOOTING
The telephone beeps every 5 seconds
This is to notify the passengers of the ongoing call (anti eaves
dropping).
The unit makes an alarm call when powered up
•
Improper type of emergency button selected. Change from NC
to NO or from NO to NC.
•
Emergency button is stuck.
No sound transmitted from the lift car to the call receiver
Press “0” to get an outside line. Make a call. If the sound
transmission is OK in both directions, check if your emergency operator supports the chosen alarm type.
If no protocol is used, change the call type to “VOICE”. If no sound is transmitted from the lift car, check
the microphone.
Poor/distorted sound quality
Volume might be set too loud! Lower the volume and check again.
Interfering noise when the call is connected
The problem might be due to induction in the phone cable. According to the phone companies’
regulations, the phone line must be installed in a separate cable.
GSM noise
Change the antenna position when a call is connected until you find the optimal antenna position. Do not
install the antenna near the unit or close to the cabelling.
Can not dial out
•
Broken line connection (LED not blinking green).
•
No money on refill SIM-card, verify the SIM-card by inserting it into a normal mobile phone.
No voice switching
•
The volume is set too high.
•
The problem might be due to induction in the phone cable.
The unit can not make an alarm call
At least one phone number (and one ID code if using data identification) must be configured to enable
making a call from the unit. Refer to the parameter list (*11*).
