![Safeline MX3 Installation Manual Download Page 13](http://html2.mh-extra.com/html/safeline/mx3/mx3_installation-manual_3313699013.webp)
13
© 2015 SafeLine and all the SafeLine products and accessories are copyrighted by law.
MX3 v1.06 EN
Configuration
Activate with DTMF 8 (Output 1, Configuration code 1)
The output is activated at the following events:
- DTMF tone 8 is received.
The output is deactivated at the following events:
- 3 seconds after activation.
Activate with DTMF 9 (Output 2, Configuration code 1)
The output is activated at the following events:
- DTMF tone 9 is received.
The output is deactivated at the following events:
- 3 seconds after activation.
System Failure (Output 1 & 2, Configuration code 2)
The output is activated at the following events:
- Telephone line OK.
The output is deactivated at the following events:
- Telephone line missing.
Emergency Bell (Output 1 & 2, Configuration code 3)
The output is activated at the following events:
- Emergency alarm button input active.
- The call is not yet connected.
The output is deactivated at the following events:
- Emergency alarm button input deactivated.
- The call is connected.
Silence Disconnect
The function will automatically disconnect a call if no sound is received from the alarm operator within a
set time. Only works for voice calls, not for P100/CPC/Q23.
The configuration is performed via SafeLine Pro or with the configuration code *92*X#, where X specifies
the time:
0
= The function is off.
1
= 30 seconds.
2
= 60 seconds (default).
3
= 90 seconds.
Software controlled volume control
The speaker volume is adjusted via the keyboard control. Key 2 raises and Key 8 lowers the volume in
6 steps. The volume can also be adjusted using the command *76*X# where X is the desired volume
position between
1
and
6
. Default value is
3
.
The set volume mode are stored in the EEPROM so that the unit remembers the set position.
External Mic / speaker part
When a call is activated by the emergency alarm button on the external mic/speaker part, the microphone
on the external mic/speaker part will be used and the internal microphone disconnected.
The speaker sound will however be heard from both speakers simultaneously.