background image

7

© 2012 SafeLine and all the SafeLine products and accessories are copyrighted by law.

ENGLISH V. 2.61

Service

TroUbleShooTing

The red led does not start flashing when unit is connected to supply voltage.

• 

Check the supply voltage polarity. 

• 

Make sure that the supply voltage is: 12 or 20-30VDC

all 4 led’s starts flashing rapidly.

• 

Make sure that the SIM-card is correctly positioned. 

• 

Check that the SIM-cards PIN-code is deactivated or that the PIN-code is set to ”0000” or ”1111” 
(see the section SIM-card). 

• 

Make sure that the SIM–card is activated and ”works” by testing the card in an cellular phone.

The call is interrupted directly after being connected.

• 

If the unit is powered from a battery make sure the battery is properly charged. 

• 

If the unit is powered from a AC/DC or DC/DC transformer make sure that it can deliver 0.25A 
continuous current.

call can not be connected! error message from telephone operator.

• 

To make a call, area code must always be used.

inTerference / poor SoUnd qUaliTy.

• 

Bear in mind that the wiring between GL2 and the lift telephone/phone is basically a “standard” 
PSTN-line and can therefore not  be placed in the lifts travelling cable together with high voltage. 
*** (Risk of interference)*** 

• 

Always place the antenna in an upward position and at least 1,5m from GL2. 

• 

Place the antenna where the highest field intensity is obtained according to the table on the unit. 

• 

When a call is connected try placing the antenna in different places to find where the best 
receiving/sending position is.

Summary of Contents for GL2









Reviews: