18
How to Pair a Remote Tag by Panel
Go to
Menu>Parts>Remote>Add
and enter.
You need to enter a digit from 0 to 9 to designate a unique number
for the remote tag to be paired.
Synchronizing
is shown, the hub goes into the paring mode and
count down the pairing time remaining.
Press any button of remote tag to send a transmission signal to the
hub.
As the serial number of remote tag is added to the hub,
Leaning OK
will be shown.
Go to
Menu>Parts>Remote>Delete
to delete the remote tag specified by serial number .
Go to
Menu>Parts>Remote>Delete All
to delete all the remote tags. Total number of paired remote
tags is shown before deleting.
How to Pair a Wireless Sensor by Panel
(Door/Window Sensor or PIR Motion Detector)
Go to
Menu>Parts>Detector>Add
and enter.
Scroll to
and tap ▲ to select the desired
Zone Name
.
To be used as doorbell, select
Doorbell
.
Scroll to
and tap ▲ to select the desired
Zone Mode
(Type).
You must assign a
Zone Mode
to each zone(sensor), which defines
the way in which the system responds to faults in that zone.
Normal:
Sensors set to
Normal Zone
are activated in Arm (full arm)
or HOME Mode (stay/partial arm). We recommend setting
door/window sensor to
Normal Zone
.
24 Hours:
Sensors set to
24H Zone
will activate the alarm and
sounding when triggered, regardless of the alarm status (Armed or
Disarmed).
Delay:
If sensors set to
Delay Zone
are triggered, the Hub will sound
the alarm after the delay time passed. We recommend setting door
sensors with a
delay
if they are used as primary entryways.
Home:
Sensors set to
Home Zone
are only activated in Arm (full
arm). If Stay Arm Mode (partial/home arm) is used, these sensors are
not armed and will not activate the alarm if triggered. We recommend
setting PIR Motion Detectors to
Home Zone
.
24 Hours Silent:
The mode is same as
24H
but sound.
To disable the zone, select
Close
.
Scroll to
use the digits keypad to enter
Zone Number
(0-89
are available), tap ▲ to backspace.
Zone Number which
should
be unique if more than one sensors need to be paired.
Select √ ,
Synchronizing
is shown, the panel goes into the
paring mode and count down the pairing time remaining.
Trigger wireless sensor to send a transmission signal to the
panel as shown on the right.
As the serial number of wireless sensor is added to the panel,
Leaning OK
will be shown.
Go to
Menu>Parts>Detector>Edit
to edit
Zone Name/Zone Mode
of selected zone specified by the
zone number, or delete the selected zone.
Go to
Menu>Parts>Detector>Delete All
to delete all the wireless sensors. Total number of paired
sensors is shown before deleting.
Press the panic button
or separate the sensor
from the magnet by at
least 1.0 inches(2.5 cm)
Press the pairing button or
place the PIR motion
detector in a high position
and then walk within the
detection area to trigger the
PIR alarm once (the
indicator light flashes once)
Set Name/Mode/Number
PIR
Normal(without delay)
1
24h