Using the magnetic contact:
The magnetic contact can be used on most
doors/windows with a gap of less than ½ inch.
1.
Mount the push button on the door
jam with the screws provided.
2.
Mount the magnet on the door
(within ½” of the push button) with the screws
provided.
3.
After mounting the magnet on the
door snap the cover on the magnet case.
4.
The magnetic contact can be used
on either side of the push button. (Figure 4)
Coding the receiver:
1.
Open the receiver case by inserting a small
screwdriver into one of the pry notches on the side of the case (refer to receiver
manual) and gently lift off the front cover.
2.
Locate the eight dip switches on the receiver and make sure they are set
identically to dip switches 1-8 on the transmitter.
*Note: If more than one transmitter is used with the receiver, the first eight dip
switches of all transmitters must match the eight dip switches of the receiver.
*Note: Whenever a change is made to the jumper or the dip switches, the receiver
must be turned off and then back on to operate properly
Using multiple detectors:
If multiple normally closed (N/C) contacts are to be used, they should be run in
series to the N/C contacts.
If multiple normally open (N/O) contacts are used, they should be run in parallel to
the N/O contacts.
*Note: Both N/O and N/C contacts can be used simultaneously along with the
magnetic contact and push button.
Mounting the transmitter:
The transmitter can be mounted to any wall
using the mounting bracket. (Figure 5)
The mounting bracket is located on the back
of the UT-2500 and can be removed by
simply sliding it off. Position the bracket
where you would like it and place two
screws in the holes provided. To place the
UT-2500 back simply slide it over the
bracket.
TECHNICAL SUPPORT
If you encounter any difficulty in the operation of this product after reading the
manual, please contact us. You can reach us by phone at 605-356-2772 from 8:30
AM to 5:00 PM Monday through Friday (Central Standard Time). We will be happy
to answer your questions and help you in any way we can.
WARRANTY
Dakota Alert warrants
this product to be free of defects in material and
workmanship for a period of one year from the date of purchase. This warranty
does not cover damage resulting from accident, abuse, act of god or improper
operation. If this product does become defective, simply return it to Dakota Alert.
Please include a note describing the troubles along with your name and return
address as well as the original sales receipt. If the product is covered under
warranty it will be repaired or replaced at no charge. If it is not covered by
warranty, you will be notified of any charges before work is done
Distributed by SafeGuard Supply, LLC.
For sales related questions, please contact:
Safeguard Supply
9655 Florida Mining Blvd. W.
Suite 401
Jacksonville, FL 32257
04-245-1184
www.1800doorbell.com
Manufactured By Dakota Alert, Inc.
For technical support, please contact:
Dakota Alert
32556 E. Main Street
Elk Point, SD 57025
605-356-2772
www.dakotaalert.com
(figure 4)
(figure 5)
