TECHNICAL SUPPORT
If you encounter any difficulty in the operation of this product
after
r
eading the
m
anual, please contact us. You can reach us by phone at
904-245-1184
from 8:
0
0 AM to 5:00 PM Monday through Friday (
Eastern
Standard Time). We will be happy to answer your questions and help you
in any way we can.
WARRANTY
Safeguard Supply
warrants this product to be free of defects in
material
and
workmanship for a period of one year from the date of purchase. This warranty
does not cover damage resulting from accident, abuse, act of god or improper
operation. If this product does become defective, simply return it to
Safeguard
Supply
. Please include a note describing the troubles along with your name and
return address as well as the original sales receipt. If the product is covered under
warranty it will be repaired or replaced at no charge. If it is not covered by
warranty, you will be notified of any charges before work is done.
Safeguard Supply
- www.safeguardsupply.com
2260 Moon Station Ct. NW #110
,
Kennesaw, GA 30144
Phone: (
678
)
214
-
4212
Mounting the
T
ransmitter
:
•
The PIR sensor (transmitter) may be mounted in a variety of
locations such as; on the ceiling, directly above the door, or
side
mounted. The most common mounting location is above
the
door.
•
For best results, mount the transmitter above the door frame
slightly canted in towards the door. You may cant (tilt) the unit
to
ensure the monitored zone is covering the area you want it
to
cover.
•
Avoid placing the transmitter near heating & A/C ducts, or in
direct
sunlight to help eliminate false signals.
•
The mounting height of the sensor (see table 1) changes the
size
of the monitored zone.
WARNING:
Cancer and Reproductive Harm. Go to
www.P65Warnings.ca.gov
for
more information.
Volume
Adjustment
:
The volume is also controlled by the "volume control and
tone selector button." To change the volume level, make
sure the unit is not in program mode. Ensure the RED LED IS
NOT lighted (Lighted RED LED means the unit is in
programming mode.)
1.
The sensor has four volume levels. By default the unit is set
to volume 4, the highest volume level.
2.
To adjust the volume, press the "volume control and tone
selector" button until the desired volume level is reached
(see
figure 2)
.
3. After a
djusting the volume, reassemble the unit.
1. Use included screw to mount the metallic bracket. We
recommend mounting the bracket so that the openings on each
end of the bracket are facing up (shaped liked a "U").
2.
Each side of the transmitter has a screw protruding. That screw
slides into the u-shaped openings of the bracket.
3.
Insert the unit into the bracket. Each screw on the side
s
of the
sensor
should rest on open ends of the u-shaped bracket.
4.
Tighten the screws on the side of the case just enough to keep it
in
place (do not let it fall out)
.
5.
Tilt sensor in bracket to create desired monitored zone and test.
6.
Tighten the screws on each side of the case to secure it to the
bracket.
Table 1
*
Height of Sensor
(in f
eet
)
Change
s
the
Width and Depth of
Monitored Zone
.
Height
Width
Depth
8’
9.20’
0.60’
10’
11.5’
0.75’
13’
14.95’
0.98’
16’
18.40’
1.20’
