Mounting t e ran
itter
Note:
•
ocation
o
Try to mount on a wooden post, fence or tree. Avoid mounting
on metal if possible.
o
Try to mount in a location free of obstacles such as metal
siding, trees that may cause transmission interfence.
o
The product has a very long range, but these obstacles will
interfere in the effective range.
o
Try to place unit - ft. off the ground appro imately ft.
from either side of driveway or path you are monitoring.
o
The sensor will detect people vehicles up to appro imately
ft. away (on high setting), sometimes even farther. or
this reason, avoid pointing the transmitter sensor at roads in
the distance.
o
a e sure unit is mounted so that it does not move during
wind or storms. This could generate false triggers.
TECHNICAL SUPPORT
f you encounter any difficulty in the operation of this product after reading
the manual, please contact us. ou can reach us by phone at
- 5-
from
A to 5
P onday through riday (Eastern Standard Time). e
will be happy to answer your uestions and help you in any way we can.
WARRANTY
Safeguard Supply warrants this product to be free of defects in material and wor manship for
a period of one year from the date of purchase. This warranty does not cover damage
resulting from accident, abuse, act of god or improper operation. f this product does become
defective, simply return it to Safeguard Supply. Please include a note describing the troubles
along with your name and return address as well as the original sales receipt. f the product is
covered under warranty it will be repaired or replaced at no charge. f it is not covered by
warranty, you will be notified of any charges
before wor is done.
Safeguard Supply
oon Station t.
ennesaw, GA
www.safeguardsupply.com
ance Sen or ran
itter Setting
Note:
•
Remove the battery. Prior to ad usting any sensor settings, please
remove the battery. Remove bac cover and disconnect the battery. See
"
Batter n tallation
•
Remove ad ust umper. umpers are small blac plastic pieces that fit
over pins on the circuit board. (figure 5).
( igure 5)
•
Gently slide the umper off the pins for the settings you would li e to
change. f you cannot use your fingers, you can use twee ers.
•
Slide the umper bac onto the pair of umper pins that correspond
with the setting you want to change (see images below).
•
ange
hanges the distance that the motion detector will
detect motion (si e of monitored one).
•
Turn LED on off (LED triggered when unit is transmitting radio signal).
•
ilter
hanges the sensitivity level of the motion detector. Recommended
O for indoor use, O for outdoor use).
•
e et
hanged minimum time between alarm activations.
•
Select a Mounting Bracket
o
Plate mount is ideal for outdoor locations (trees, posts, fence).
See figure .
o
Swivel mount is ideal for indoor locations (figure ).
•
Select a Mounting Bracket
o
Ensure arrow on brac et is facing up.
o
Slide transmitter down on brac et. LED on transmitter
should be towards the top of the case to function correctly.
(figure ).
( igure )
(Figure 6)
