EN
EN
TECHNICAL SPECIFIKATION
FEATURE DESCRIPTION
•
Lock case (scandinavian module)
•
Built-in logic for motor control and indications.
•
Indication of "Bolt out" and "door closed".
•
Potential free connection for activation.
Power Supply
Continuous voltage between red and green wire 12-24 Vdc + - 10% required for lock to operate
Activate
To unlock, a potential free connection between yellow and black
cable requires and door magnet is activated.
When bolt reached its inner position it changes status of the bolt indicator.
A closed circuit (from eg. acces control) unlocks the lock and after
three seconds bolt locks out. A constant connection works as
day blocking and keeps bolt unlocked until the connection breaks. (eg clock).
Thumb turn / Cylinder
For manual activation with knobs or key bolt must reach
inner position within three seconds for a valid activation.
Three seconds delay before bolt is locked out.
Locking
After a valid activation,door magnet must be detected before
bolt runs out and locks the door, and bolt indicator change status.
Blocking
When bolt is blocked, the current movement stops and bolt
switches position, after two seconds, another attempt to lock will start.
Bolt-position indicator switches status when blocking has been eliminated
and bolt has reached its correct position.
Manipulation
If the bolt, without a valid activation, loses contact with the "bolt out" sensor,
an attempt to lock will be made. If bolt is blocked,
the relay changes status to "Bolt in", while
further attempt to lock is implemented.
Only when bolt reaches outer position or get a valid activation,
this procedure will stop.
Summary of Contents for ML 128
Page 12: ... EGNA ANTECKNINGAR ...
Page 13: ... EGNA ANTECKNINGAR ...
