Page 2
www.safe-t-cover.com 1-800-245-6333
Version 2.0
the inside length of the enclosure during assembly progress. If the length does not match the length
given in the table, compensate by increasing or decreasing the suggested 3/16” gap until the inside
length is correct. Try to maintain the same gap at all gap locations.
FIG. 2
6.
Set the “D1” (roof) panel on a “BS-A-BL” (corner-end-corner) assembly and then fasten it as shown
through the holes provided (Fig. 2) using two (2) Hex Head Screws.
7.
Repeat the roof assembly process for the “D2” (roof) panel on the other “BS-A-BL” (corner-end-
corner) assembly.
FIG. 3
D2
D1
