www.safehome.dk
5
3.2 Enrolling GSM Dialer with the Smart Panel
In order to use the GSM Dialer with the Smart Panel you will need to enroll the compo-
nents. This will allow the Smart Panel to recognize and interact with the GSM Dialer.
The enrolling procedure must be completed in order for the GSM Dialer to work properly.
If the procedure is not completed then the GSM Dialer will not respond to system input.
IMPORTANT:
In most cases the factory settings of the House security Code will NOT need to be
changed. However if the Smart Panel and sensors activate intermittently or are unrespon-
sive this may be due to interference with other radio frequency systems. You may wish
to change the house codes ensuring that they are identically arranged in both the Smart
panel and GSM Dialer.
There are 4 jumpers/dip-switches on each device. They can be found when you remove
the battery compartment cover. When the jumpers are present the circuit is ‘ON’. If
absent the circuit is ‘OFF’. Ensure that these settings are identical if you need to make
modifi cations to the panel, sensors and any remote control device.
Jumpers for House
Security Code
Default code:
1: ON, 2: ON, 3: ON, 4:ON
Jumper: ON= Pushed in, OFF= Pulled out
Enroll the GSM Dialer by following this procedure:
a. Enter the 4 digit pin on the Smart Panel and press the SETTING button and ‘2’ (Enroll-
ment mode).
b. Simultaneously hold down the RECORD and RESET button on the back of the GSM
Dialer for two seconds
c. Several beeps from the Smart Panel will indicate that the enrollment is successful
d. Press ENTER on the Smart Panel to exit the enrollment mode
