PRIME DESIGN, A SAFE FLEET BRAND
▪
Address: 1689 Oakdale Avenue #102, West St Paul, Minnesota 55118
▪
Toll Free: 1.8.PRIME.RACK
▪
Fax: 651-552-1799
▪
Email: [email protected]
▪
Website: www.primedesign.net
TM & © 2020 PRIME DESIGN. PROTECTED BY ONE OR MORE OF THE FOLLOWING PATENT NO.’s 6427889, 6764268, 6971563, 8991889, 9415726, 9506292, 9481313, 9776476, 9796340, 10470565, 10486608 AND OTHER PATENTS PENDING
7
View From Vehicle Front
Fig. D
L Post Bolt
Fig. E
Fig. F
Flat Washer
Lock Washer
M8 x 20MM Hex Bolt
Do not tighten
VRR3-FT21G-ST BO
X
ASSEMBL
Y INSTR
UCTIONS–L POSTS & Z POSTS
1.3
Place the Slide L Post Bracket Clamp into the inner bottom
groove of the Slide Assembly, then position it into the L Post
Bracket. Assemble the Slide L Post hardware, but do not
tighten until Step 1.4
Note:
The orientation of
the bolt hole faces away
from the Slide Upper.
Lightly tighten the Slide L Post bolt, then finalize the alignment
of the front edge of the Slide L Post as shown below in Figure D.
This must align to the label’s L Post positioning arrow shown in
the closeup in Step 1.1. Torque the L Post bolt to 90 in-lbs.
1.4
SLIDE Z POST
2.1
Place the Slide Z Post Clamp onto the top of the Slide
Assembly, ensuring the Z Post Clamp seats into the Slide
Upper lip as seen in Figure E below.
2.2
Place the Z Post into the Mounting Clamp Assembly ensuring
the Slide Z Post seats into the Clamp’s top groove as seen in
Figure F below. Do not tighten until of Step 2.4
Summary of Contents for PRIME DESIGN VRR3-FT21G-ST
Page 1: ......
Page 11: ...Page Intentionally Left Blank...
