Prime Design Limited Warranty. Seller’s sole and exclusive warranty (and Buyer’s sole and exclusive remedy and Seller’s entire liability for any breach thereof) with respect to the Goods is set forth in the Limited Warranty document available at primedesign.net/warranty-liability
(the “Prime Design Limited Warranty”).
▪
TM & © 2021 PRIME DESIGN. PROTECTED BY ONE OR MORE OF THE FOLLOWING PATENT NO.’s 6427889, 6764268, 6971563, 8991889, 9415726, 9506292, 9481313, 9776476, 9796340, 10470565, 10486608, 10501022 AND OTHER PATENTS PENDING
7
M8 x 20mm
Lock Washer
Flat Washer
Flat Washer
M8 Lock Nut
Front of V
ehicle
DPS-8001 ASSEMBL
Y
INSTR
UCTIONS–ST
OPS AND
HOLDERS
LADDER HOLDERS
4.1
Attach Two (2) Ladder Support Connecting Brackets to the
Top Sliding Assembly using the hardware shown below. Do
not tighten screws until Step 4.3
Do not tighten.
Attach the Ladder Holder Assembly to the Connecting
Brackets using the hardware shown below. Center the
Holder from left to right before tightening. This Ladder
Holder can be adjusted later according to the ladder
being carried.
4.2
Torque all bolts
to 90 in-lbs
4.3
Repeat Steps 4.1 & 4.2 to attach the remaining Ladder
Holders to the Top Slide. The Ladder Support fitted with the
End Stops is to be positioned toward the top of the Rack.
4.4
Torque all bolts
to 90 in-lbs
4.5
Install the Ladder Holder Padding into the top groove of the
Holder’s Crossbar. This piece is to be cut-to-fit for the top and
bottom Holder fitted with the Ladder Stops once they’ve been
properly adjusted for the ladder being carried.
4.6
The padding interlocks
into the Holder
Crossbar as shown.
