LMU Controller
© Safe Fleet | March 2019 | All rights reserved | Part #: 700-1132 R3
p. 7
Installation
Install LMU Controller
1.
Select an LMU Controller modem installation location that meets the following requirements:
CAUTION: Installation Requirements
•
The LMU Controller must be installed within the range of the Antenna cable distance.
• Install within the vehicle, close to the DVR if possible.
• Install where LEDs can be seen if necessary.
• Install in the front of the vehicle.
•
Route the wiring and cables away from sharp edges that might damage the insulation.
• Avoid sharp bends in the cable.
Installation Requirements
Location
Choose a dry location with easy access to the electrical panel and cable connections to mount the
LMU Controller.
Check that the LMU Controller location is within the maximum reach of the antenna cable.
Install the LMU Controller away from any place where tampering with the device or cable connections
may occur.
Surface
Do not mount the LMU Controller to a plastic panel or other surface that is subject to constant
vibration.
Clearance
Allow sufficient clearance of at least six (6) inches in front of the LMU Controller and two (2) inches
on each side for easy access and removal of cable connectors and ports.
Allow sufficient clearance behind the LMU Controller for antenna and power cables.
Harnesses
Provide enough slack on the power cable to prevent any force from being exerted on the connectors.
A single 4-inch diameter loop is sufficient.
2. Using the supplied alcohol wipe pad, clean the vehicle surface where the LMU Controller will be installed.
3.
Peel the protective cover from the velcro backing on the LMU Controller. Be careful not to touch or allow any foreign
material to come in contact with the exposed adhesive.
4. Attach the LMU Controller to the vehicle.
5.
Connect all power, alarm, GPS, and Stop Arm cabling to the LMU Controller 20 pin harness using the following
diagram.