Carefully lay the unit on its left side. Using a soft hammer or
mallet, tap the N Hinges into the recesses on the O Left Door
Panel. Use the pre-installed screws to fasten the P Hinge Mount
Plates into the pre-drilled holes on the Left Panel. If the Hinge and
Mount came in separate pieces, bend the arms of the Hinges and
insert the slots of the arms over the Hinge Mount Plate set screws.
Adjust door position and tighten the set screws. Turn the unit onto
its right side, and repeat with the Q Right Door Panel. Attach the
JJ Door Plate to the left door with one E Flat-Head Screw. Part of
the Door Plate will extend beyond the edge of the door.
8962-37: 3 of 4; Rev. 1; 05/07
Safco Products Company, New Hope, MN 55428
Position the J Bottom Panel so the Screw Posts
line up with the holes in the bottom ends of the left
and right Side Panels, and with the arrows on the
Locking Cams pointing toward the Screw Posts,
insert the Screw Posts into the holes and secure by
turning each of the engaged cams CLOCKWISE as
far as they can turn.
5
Fasten the two K Swivel Casters with Brakes near
the front edge of the Bottom Panel using four L
Screws per caster. Fasten the two M Swivel
Casters to the other end of the Bottom Panel near
the back using four L Screws per caster.
6
J
M
7
FRONT
BACK
K
L
SCREW
POSTS
LEFT
PANEL
O
P
N
N
P
SET
SCREW
TIGHTEN
SET
SCREW
ARM
SLOT
Q
RIGHT DOOR PANEL
NOT SHOWN
Carefully stand the unit upright. Insert keyhole side of
the R Lock Assembly (with keys removed), into the
large hole in the Q Right Door Panel from the interior
(hinge side). Fasten the lock assembly to the door
using two E Small Screws.
Fasten the S Lock Plate to the underside of the Half-
Shelf using two E Small Screws.
Insert the four T Shelf Pegs into the desired set of
holes (all on the same level) in the center of each Side
Panel. Slide the U Adjustable Shelf into position,
with the finished edge toward the door opening.
If necessary, center the Door Panels by adjusting the
set screws on the Door Hinges as needed.
Prevent the assembled unit from rolling by activating
the brakes on the Swivel Casters with Brakes.
8
SWIVEL CASTERS
WITH BRAKES
E
Q
HALF-SHELF
R
T
U
S
JJ
E
