Lay out the H Half-Shelf and the I Back Panel with the
large holes facing up, and the J Bottom Panel with the
side that has only four holes facing up.
Insert D Locking Cams into the large holes in the back
panel and Half-Shelf with the arrows pointing toward the
nearest SIDE edge. Insert four C Screw Posts into the
Bottom Panel.
F
8962-37: 2 of 4; Rev. 1; 05/07
Safco Products Company, New Hope, MN 55428
Raise the B Right Side Panel so it is perpendicular
to the work surface with the roller of the Cabinet Rail
up. Align the three Screw Posts along the back
edge of the Side Panel with the corresponding holes
on the right edge of the I Back Panel. With the
arrows on the Locking Cams pointing toward the
Screw Posts, insert the Screw Posts and fasten by
turning each of the engaged cams CLOCKWISE as
far as they can turn.
IMPORTANT:
to prevent possible damage during
assembly, a second person should help keep the
panel supported in its upright position.
3
Locate the A Left Side Panel and the B Right Side Panel, and
lay them down on a smooth, clean surface with the holes facing
up. Insert three C Screw Posts into the holes at the back edge
of both Side Panels. Insert two Screw Posts into the holes near
the upper end of each Side Panel as shown. Insert D Locking
Cams into the LARGE holes of the Side Panels with the arrows
pointing toward the nearest TOP or BOTTOM edge. Using three
E Small Screws, attach the F Left Cabinet Rail to the A Left
Side Panel, just below the upper Locking Cams and with the roller
end closest to the front. Make sure the front screw uses the hole
nearest the roller. Repeat with the G Right Cabinet Rail on the
B Right Side Panel.
1
B
I
SCREW
POSTS
CAMS
Raise the A Left Side Panel so it is perpendicular to
the work surface. Align the three Screw Posts at the
back of the Side Panel with the corresponding holes
on the left side of the Back Panel, but do not push
the panels together yet. With the Cams of the H
Half-Shelf facing the bottom of the unit, align the
holes in the ends of the Half-Shelf with the Screw
Posts near the front edges of both Side Panels. With
the arrows on the Locking Cams pointing toward the
Screw Posts, carefully slide the parts together and
fasten by turning each of the engaged cams CLOCK-
WISE as far as they can turn.
4
A
H
B
D
CAMS
BOTTOM
ROLLER
Q
Q
Q
Q
Q
G
Q
Q
Q
Q
Q
F
Q
Q
Q
Q
Q
I I
Q
Q
Q
Q
Q
HH
Properly identify the
four types of rails
used!
The Cabinet Rails F ,
G have C-shaped
cross sections; rollers
are at the FRONT, and
the Left Cabinet Rail is
stamped “CL” near the
roller, while the Right
Cabinet Rail is
stamped “CR”.
The Drawer Rails HH ,
I I have L-shaped
sections; rollers are at
the BACK, and they
are stamped “DR” for
Right and “DL” for Left.
USE THIS HOLE
FOR FRONT
SCREW
A
E
C
G
2
H
I
J
D
C
FRONT
FRONT
