1
2
3
4
1852-37: 3 of 4; Rev. 1; 05/03
FRONT
O
Push the two N Casters with
Brakes into the sockets of the
Caster Brackets at the front of
the unit. Push the two O Casters
without Brakes into the Caster
Brackets near the back side of
the unit.
5
S RIGHT DOOR PANEL
NOT SHOWN
LEFT
SIDE
PANEL
Use a rubber hammer or mallet to tap the P Hinges into the
recesses on the R Left Door Panel. Use the pre-installed
screws to fasten the Q Hinge Mount Plates into the pre-drilled
holes on the Left Side Panel. If the Hinge and Mount came in
separate pieces, bend the arms of the Hinges and insert the
slots of the arms over the Hinge Mount Plate set screws. Adjust
door position and tighten the set screws. Turn
the unit onto its right side, and repeat with the
S Right Door Panel.
6
ARM
SLOT
SET
SCREW
TIGHTEN
SET
SCREW
N
P
Q
FRONT
(FINISHED
EDGES)
Position the F Top/Bottom Panels
over the B Left Side Panel with the
cams toward the bottom end, and
finished edge facing out. With the
arrows on the Cams pointing toward
the Posts, insert the holes
over the Posts and fasten
the posts to the cams by
turning the cams CLOCKWISE
until they stop.
Insert one dowelled end of
the L Kick Panel into the
Left Side Panel in the holes
nearest the front, bottom
end of the side panel.
Lift the C Right Side Panel
over the assembly. Align the
Screw Posts with the
corresponding holes on
the Back Panel, and both
Top/Bottom Panels (also
guide the Wood Dowels
on the Kick Panel into the
holes in the side panel), then
fasten the posts to the cams by
turning the cams CLOCKWISE
until they stop.
4
BOTTOM
END
CAMS
F
A
With two people, carefully stand the unit
upright. Fasten one T Handle to the
outer side of the Left Door Panel using
two U Long Screws. Fasten the other
Door Handle to the outer side of the
Right Door Panel with two more Long
Screws.
If necessary, center the Door Panels by
adjusting the set screws on the Door
Hinges as needed.
7
U
T
B
C
L
P
Q
R
P
