18
D) Installation instructions
Bolting on the brake calliper
Position the brake calliper and screw in M 16 x 1.5 x 55 collared
bolts (tightening torque 290 Nm).
Coat ABS sensor (see arrow) all around with copper paste and install
in the sensor holder.
Push in the ABS sensor until it contacts the exciter.
Measure the output voltage at the ABS sensor cable using a volt-
meter (approx. 100 mV) while turning the brake disc or wheel
flange.
Checking the folding bellows on the pressure pad
Checking the protection cap and the moveability of the brake
calliper:
Move the brake calliper in the direction of the cylinder and check
the protection cap 80, 66 the guide pin 70.1/80.2 and the adjust-
ment screw forwear or damage. If necessary replace the protection
cap (page 22)!
Note!
Should the protection cap 66 become defect, check to make sure no
dirt or water has entered the inside of the brake or that the seal
seating has not been damaged by corrosion. In case of doubt the
brake should be replaced. If the protection cap 66 becomes dama-
ged during service this must also be replaced (see page 22).
Manually move the brake calliper on the guide pin over the whole
length of travel and check for ease of movement.
If movement is difficult replace both the bushes and the protection
cap.
Note!
Do not squash the guide pin's protection cap against the brake
mounting.
80, 80.2 66
80, 70.1
Summary of Contents for SK RB 9019 W
Page 4: ...NOTIZEN NOTES NOTE 4...
