12
Installation Instructions
XL-FW10064BM-en-US Rev A · 2011-12-02 · Amendments and errors reserved. © SAF-HOLLAND, Inc.
Figure 23
Figure 24
9. Sensor Position Check
1. Lock the fifth wheel top plate using a Holland lock tester
TF-TLN-5001 and flip the top plate upside down.
2. Check to make sure the cam plate
(Figure 22)
and
the kingpin
(Figure 23)
BSFCPUIXJUIJOPGUIFJS
respective sensor. Pull the cam plate, by hand, away from
the sensor as far as possible when checking the distance.
The cam must not be able to touch the sensor. The cam
sensor bracket may be bent slightly to adjust its distance
from the cam. To avoid damaging the sensor, only pry on
the metal when bending the bracket. DO NOT pry on the
sensor. After adjusting, push cam towards sensor, making
sure they do not touch.
3. Remove the lock tester and check that the kingpin sensor
is not to close to the locks when they are open. There
TIPVMECFBNJOJNVNPGCFUXFFOUIFTFOTPSBOE
the bottom of the locks
(Figure 24)
. If the distance
is close the kingpin bracket can be bent slightly. After
adjusting away from the locks, recheck the distance to
the kingpin by use of the lock tester.
,*/(1*/
4&/403
,*/(1*/
)&"%
5)&3&4)06-%#&"("10'03-&44
#&58&&/5)&,*/(1*/"/%5)&,*/(1*/4&/403
Figure 22
CAM PLA
TE
3/8"
THERE SHOULD BE
A GAP OF 3/8" OR
LESS BETWEEN THE
CAM PLATE AND
THE CAM SENSOR
CAM SENSOR
-0$,4
,*/(1*/
4&/403
.*/*.6.#&58&&/4&/403
"/%#0550.0'-0$,4
Summary of Contents for Holland ELI RK-10855-L
Page 16: ...THIS PAGE INTENTIONALLY BLANK...
